Spin Master Motorized Toy Car Regenerator User Manual

IMPORTANT! PROBLEMS?  
Before taking Crash Force™ Regenerator™ RC  
back to the retailer, call our friendly  
RC technicians at: 1-800-622-8339  
STORAGE: The Crash Force™ Regenerator™  
RC should be stored indoors in the box and  
foam tray after each use.  
After  
Impact!  
CRASH FORCE™  
REGENERATOR SUV™  
BATTERY INSTALLATION  
Crash Force™ Regenerator™ is designed to work with standard RC 6-Volt NiCad batteries and charger,  
sold separately. If you do not have a 6-Volt battery and charger, Crash Force™ Regenerator™ can operate with  
Five-AA batteries. • Controller is designed to work with a 9-Volt battery, sold separately.  
INSTALLING BATTERIES IN THE REGENERATOR™  
compartment, making  
sure to follow the  
6 VOLT  
Battery  
1 - To install the  
6-Volt battery, rotate  
the door locks to the  
sides of the battery  
compartment door  
as shown.  
correct + and –  
Turn  
Vehicle  
Over  
Compartment  
Door  
2
polarity markings.  
Then fold the internal  
battery adjuster out,  
to hold the 6-Volt  
battery in tight.  
6-V  
Battery  
1
3
Lock  
Battery  
Compartment  
2 - Remove the battery 4 - Replace the battery  
Battery  
Compartment  
Door  
compartment door.  
3 - Place the battery  
in the battery  
compartment door and  
rotate the door locks  
to their “Lock” positions.  
Lock  
3 - Place the batteries  
in the battery tray  
AA BATTERIES  
1 - To install the AA  
according to the + and  
– polarity markings.  
2
Turn  
Vehicle  
Over  
batteries, rotate the  
Battery  
Compartment  
Door  
door locks to the sides 4 - Place the battery  
of the door as shown.  
2 - Remove the battery  
compartment door  
and make sure the  
internal battery  
tray into the battery  
compartment.  
5 - Replace the battery  
compartment door and  
rotate the door locks  
to their “Lock” positions.  
1
Lock  
Five-AA  
Battery  
Compartment  
Door  
Batteries  
Lock  
adjuster is folded in,  
out of the way.  
3
Battery  
Tray  
Phillips Screw  
Battery  
INSTALLING CONTROLLER  
1
9 VOLT BATTERY  
4
Compartment  
Door  
1 - Using a Phillips screwdriver, undo the  
hold down screw and remove the battery  
compartment door.  
9-V  
Battery  
2
2 - Place the 9-Volt battery in the battery  
compartment, making sure to follow the  
correct + and – polarity markings.  
3 - Replace the battery compartment door  
and refasten the hold down screw.  
3
Battery  
Compartment  
Battery  
Compartment  
 

SIIG Computer Drive 04 0322C User Manual
Sony Computer Monitor SSM 121 User Manual
Sony Printer DPP EX50 User Manual
Sony Projector VPL PX32 User Manual
Sony Stereo System STR SL40 User Manual
Splendide Washer Dryer WDC1025MCEE User Manual
StarTechcom Laptop Docking Station USB3SMDOCKHV User Manual
Sunbeam Fan HAOF1265 User Manual
Sunbeam Wok WW7500D User Manual
Sungale Digital Photo Frame PF801 User Manual